The super resistant anti-theft for two-wheeled vehicles coated by a soft touch silicon gripDiscover more
Excellence for manual transmission X model
Excellence for manual transmission W model
Excellence for manual transmission K model
Hold the Bullock® lock by its grips, insert the key and turn to open the anti-theft device. Make sure that the “Bullock® Excellence" sticker is turned upwards.
Take the key out of the lock. Insert the Bullock® lock between the brake pedal and the clutch. Make sure that the crosspiece with the red safety balls sits on the car floor. If it does not, lengthen or replace the end adapter. Push forward on the grip until the clamps close automatically around the pedals.
To remove the Bullock® lock, hold the anti-theft device by its grip, insert the key into the lock and turn. The device will unlock and immediately release the pedals.
Further information - To make the Bullock® lock even more efficient, you can lengthen the shaft with the safety balls on the end up to 20 mm!
Further information - After placing the Bullock® lock around the pedal, check to make sure that it is perfectly blocked. If it is not blocked correctly, it is possible to lengthen the upper shaft to an optimal length (+ max. 20 mm) by turning the screw on the top of the end adaptor. This adjustment will allow the crossbar with the safety balls to touch the car floor and the clamp will block the pedal completely. Always leave the Bullock® lock in that position, without doing anything else to block it. To replace the end adaptor, check the parts available inside the case of your Bullock® model lock.